Vasco E-Volve E-V, Руководство по детальной настройке

Страница: 32 / 52

08 INSTALLER SETTINGS
DEFAULT FACTORY SETTINGS
If PIN code protection is deactivated, you can reset the user and
installer parameters to their original value.
1- After setting the PIN code, press until
rest
is displayed.
2-
nO
flashes. Press or to select
yes
.
Parameters Factory values
Window open detection Activated
PIN code protection Deactivated
PIN code value 0000
In addition to re-initialising the operating values and user settings
(see table page 5), the installer setting values will be re-initialised:
Customising the PIN code
If you have just activated the PIN code, follow the steps described
below.
Otherwise, you must repeat initialisation steps 1,2,3 and 4 as well
as activation steps 1and 2 before any customisation.
Customisation can only be carried out after the PIN code has
been initialised and activated.
1- When
On
is displayed , press for at least 5 seconds.
2- The code 0000 is displayed and the 1st digit flashes. Using
or , select the desired digit and then press to confirm it.
Continue in the same way for the 3 remaining digits.
3- Press to confirm. The new code is now stored.
4- Press again to exit from the PIN code configuration mode
and return to the start of installer settings.
5 sec.
1 2
Press 2x to confirm and exit installer settings.
Press 2x to confirm and exit installer settings.