Vascat ID Series, Руководство по эксплуатации и обслуживанию

Страница: 55 / 64

OPERATION AND MAINTENANCE MANUAL
ID MOTORS
PAGE: 55
CODE: CTT52 EDITION: 03 RELEASE: APRIL 2019
Subject to technical changes without prior notice
6.2.5 Replacement of motor brushes
The brush-holders are only accessible through the inspection windows, as shown by the following figures:
Figure 17: Access to motor brush holder.
In order to access the brushes on the lower position, it will be necessary to rotate the brush-holders ring, as there is not enough
space below to access and remove these brushes:
Figure 18: Detail of the rotation to access the lower brushes.
The brushes shall be changed in case their length is 14mm or less. To that end, follow the procedure as follows:
1. Unscrew the 4 screws of the guards from the inspection window.
2. In order to access the lower brushes, loosen or remove the 4 screws securing the brush-holders ring.