8.4’ DiamondVue User Guide 150.028
2.2
Unpacking and setting up your display
Your LCD monitor package will consist of the components listed below. Open shipping
container and lay all components on a flat clean surface.
What is included with your display
⇒
VT084P, VT084C, VT084W LCD Monitor
⇒
5 ft Video Cable.
⇒
+12VDC power connection. (115/220VAC “Brick” Power Supply is optional)
⇒
10-32 Mounting Hardware. (For use with Panel Mount only)
⇒
6 ft RS232 Touch Interface Cable (Optional when touch is installed)
⇒
CD ROM with Touch Screen Drivers (Optional when touch is installed)
⇒
Users Manual
2.4
Connecting the Display
1. Connect all cables to the computer first. This would include the VGA cable and the
optional RS 232 serial touch screen connection.
2. After connecting the cables between the LCD monitor and the computer, plug the
customer su12VDC source to the 12V connection on the rear or the 12VDC
connection from the output of the optional 115/220VAC supply.
3. Once the +12V or the 115/220VAC connection is made, the display is active.
4. If your computer was off, turn on your computer.
5. Your display should now operate as a normal computer display showing your windows or
whatever video is being sent to the flat panel.
2.5
Signal Connections
To avoid irregular operation and /or damage to the display, please insure correct video is
being supplied as shown on the following page.
4
2.3
Note:
If for any reason the display goes blank and gives an “out of Range” or “No Input Signal”,
your computer or video source is putting out a signal that is out of range of the LCD’s video
board. If this happens, reboot the computer or video source and make sure you are inputting
the correct signal. If the display doesn’t work properly, it may be because:
(a) The resolution is to high or low for the LCD.
(b) The refresh rate is set to high. Refresh on an LCD is different than a CRT. Set the refresh to
60Hz. CRT’s need a high refresh rate to avoid flicker. The refresh rate has no impact on
LCD’s.
(c) The power source is incorrect.
(d) The unit is malfunctioning. If you believe this to be true, disconnect the video cable from the
rear of the LCD and connect to a known good computer CRT display. If the computer
display is working satisfactory and the video is within the appropriate range, then contact
Vartech Customer service for a RMA number at 800-223-8050.
