4
Installation/Connection
www.varta-electronics.ru
InsTallaTIOn
General notes
• Choose the mounting location where
the unit will not interfere with the normal driv-
ing function of the driver.
• Before finally installing the unit, connect
the wiring and make sure that the unit works
properly.
• Consult with your nearest dealer if
installation requires the drilling of holes or
other modifications of the vehicle.
• Install the unit where it does not get
in the driver’s way and cannot injure the pas
-
senger if there is a sudden stop, like an emer-
gency stop.
• If installation angle exceeds 30° from
horizontal, the unit may not perform properly.
• Avoid installing the unit where it would
be subject to high temperature, such as from
direct sunlight, or from hot air, from the heater,
or where it would be subject to dust, dirt or
excessive vibration.
Din front/Rear-Mount
This unit can be properly installed either
from ‘Front’ (conventional DIN Front-mount)
or ‘Rear’ (DIN Rear-mount installation, utiliz
-
ing threaded screw Holes at the sides of the
unit chassis). For details, refer to the following
illustrated installation methods.
1. DIn front-mount (Method a)
3
2
1
182
53
1. Car dashboard
2. Sleeve
3. Screw
4. Nut (5 mm)
5. Spring washer
6. Screw (5 х 25 mm)
7. Metal strap
8. Flat washer
3
5
4
6
8
1
7
1. Install the sleeve into the dashboard;
ensure it is installed with the correct side and
there are no obstacles (wires, dashboard ele-
ments, etc) for the unit installation.
2. After installing the sleeve into the dash-
board, bend tabs fitting to the size of the
dashboard to fix the sleeve in place.
3. Use the metal strap to fix the rear side
of the unit. Determine a place for fixing and
install the strap as shown in the picture. You
can bend the strap to the needed angle with
your hands.
4. Make the necessary wire connections.
Ensure the connections are correct.
5. Install the unit into the sleeve until the
side locks are fixed.
Dismantling the unit
c
b
а
