Varta V-AVD22T, Инструкция по эксплуатации

Страница: 6 / 81

AVD22T
6
Installation
The unit is designed for 12V DC, negative ground operation system only. Before installing the unit, make sure
your vehicle is connected to DC 12V negative ground system.
Be sure to connect the color-coded leads according to the diagram. Incorrect connections may cause the unit
to malfunction or damage the vehicle’s electrical system.
Be sure to connect the speaker (-) leads to the speaker (-) terminal. Never connect the left and right channel
speaker cables to each other or to the vehicle body.
Make sure all the connections are completely correct before turning on your unit.
When replacing the fuse(s), the replacement must be of the same amperage as shown on the fuse holder.
Do not block vents or radiator panels. Blocking them will cause heat to build up inside and may result in fire.
After completing the installation, please remove the front panel at first, and then press RESET button on the
base with pointed object (such as ball-point pen) to set the unit to initial status.
Use only the parts included with unit to ensure proper installation. The use of unauthorized parts can cause
malfunction.
Consult with your nearest dealer if installation requires the drilling or other modifications of the vehicle.
Install the unit where it does not interfere with driver’s actions and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
The semiconductor laser will be damaged if it overheats, so don't install the unit in hot place, for example,
near a heater outlet.
If installation angle exceeds 30 from horizontal, the unit might not give its optimum performance.
The cords must not cover up the area shown in the figure below. This is necessary to allow a normal heat
exchange of the unit.