Varta 56650 764 098, Техническое руководство

Страница: 16 / 33

17
7 Setup a system
7.1 Mechanical connection
Important! When installing the module in your application, it is important to ensure that load-bearing is
evenly spread. Pressure or weight in a single area, especially on the metal plate is not allowed and
may cause damage to the battery and internal components. For example, it is not allowed to fix the
modules with a strap or similar where all of the weight could be carried in one small area. The
pressure must be spread over the whole module.
The modules can be connected in “x1” or “z2” direction for Easy Blade. For Easy Block “x3” and or
“y3” directions are possible via two module connectors, shown below in black. Place the module
connectors inside the recess of two modules (see below picture). The module connectors are
asymmetric and have a broad and a narrow side. If the orientation of the modules is wrong (e.g. in
case of serial connection of the modules), the connectors will not fit properly. When the module
connector is placed, insert a screw (Screw Wuerth Wueplast W1423 3x8, TX8 or Screw EJOT Delta
PT WN5454 30x8, TX10) and tighten it with a torque of max 0.16 Nm). The module connector will
expand and jam in the recess.