VARSITY Scoreboards 3314, Руководство по установке

Страница: 14 / 16

14
1 /
Before the sponsor panel is
lifted into place, attach the
mounting brackets to the
edge that will be away from
the scoreboard, using the
supplied hardware. Each
panel is pre-drilled for the
hardware. The brackets fit
inside the flange of the panel.
NOTE: To avoid damaging the
finish on the sponsor panel,
a flat washer should be used
under each bolt and nut (See
Figure 1) .
2 /
Lift the sponsor panel into
place with the panel resting
on top of the scoreboard for
top- mounted installations
or against the bottom of
the scoreboard for bottom-
mounted installations. The
face of the panel should be
flat against the scoreboard’s
front flange (See Figure 1) .
3 /
Using the supplied hardware
attach the mounting brackets
to the scoreboard’s back
flange (See Figure 1) .
4 /
Install self tap screws through
the scoreboard’s front flange
and into the sponsor panel
face, spaced evenly.
NOTE: To avoid damanging
border striping please drill
approximately 1 inch from
the edge of scoreboard’s
flange.
Self Tapping Screw
Sponsor Panel Face
Scoreboard Flange (1.5”)
Scoreboard Front
Top of Scoreboard
MOUNTING
3/8” FLAT
3/8-18 HEX
3/8-16 X 3/4”