VARO Powerplus XQ POWXQG4070, Руководство пользователя

Страница: 10 / 20

POWXQG4070 EN
Copyright © 2014 VARO P a g e | 10 www.varo.com
WARNING: Never start or operate the saw unless the bar and chain are
properly installed.

Fill the fuel tank (A) with correct fuel mixture.

Fill the oil tank (B) with correct chain and bar oil...
9.2 Starting a cold engine

Activate the chain brake (move the hand guard forward and engage it) (Fig 9a)

To start the saw, push the switch (ON/OFF switch) to the ON (I) position. (Fig. 9b)

Pull out the choke (A) to the point where it latches in place. (Fig. 9c)

Press primer bulb 3 to 5 times.

Push in the decompression valve to start easier. (Fig 9c2)

Place the saw on a firm and level surface. Hold the saw securely with your foot as
illustrated. Pull the starter several times until first firing sound is heard. (Fig. 9d)

Choke will be turned off automatically when you pull the throttle. (Fig. 9e)

Forcefully pull the starter until the motor engages. (Fig 9f)

Slightly press in the throttle (Fig 9g)

Pull back the brake lever to release the chain brake (Fig 9h)
9.3 Warm start

Activate the chain brake (Fig 9i)

Set the switch (on/off) to ON(I) position (Fig 9j)

Forcefully pull the starter until the motor engages (Fig 9k)

Slightly press down on the throttle (Fig 9l)

Release the chain brake (Fig 9m)
9.4 When engine is saturated with fuel

Remove the air filter

Remove the spark plug

Position the machine in an angle of 45° with the sword upwards

Pull the starters rope a few times

Clean the spark plug and place back

Place back the air filter and start without choke
9.5 To stop engine (Fig 9n)

Release trigger and allow engine to return to idle speed.

Push the I/O (on/off) switch to O (off) to stop engine.
Note: for emergency stopping, simply activate chain brake and switch the
I/O (on/off) switch to o (off).
9.6 Chain brake operational test
Test the chain brake periodically to ensure proper function.
Perform a chain brake test prior to initial cutting, following extensive cutting, and definitely
following any chain brake service.
Test chain brake as follows:

Place saw on a clear, firm, flat surface.

Start engine.

Grasp the rear handle (A) with your right hand (fig. 10).

With your left hand, hold the front handle (B) [not chain brake lever (C)] firmly (fig. 10).

Squeeze the throttle trigger to 1/3 throttle, then immediately activate the chain brake lever
(C) (fig. 10).