POWXQ5401
EN
Copyright © 2014 VARO NV
P a g e
|
5
www.varo.com
7.1
Attaching the sandpaper
Disconnect the tool from the power-supply before changing sanding paper.
7.1.1
Paper clamps
Open the paper-clamps on both sides of the base-plate and remove the worn-out sanding-
paper.
Place a new sanding-paper on the base-plate observing the holes in the sanding-paper fit
to the holes of the base-plate.
Bend the paper to the base-plate and fasten one clamp first. Press the sanding-paper
against the base-plate, bend the other end and fasten second clamp.
Attention: This finishing sander is not suitable for wet sanding jobs.
7.1.2
Hook-and-loop system
To attach sanding paper, first remove all dirt or foreign matter from the sanding base plate.
Then attach the sanding paper to the sanding base plate, using the hook-and-loop system
of the sanding paper and the sanding base plate.
Make sure the perforations in the paper coincide with those on the sanding base plate, to
ensure optimal dust collection.
The sandpaper should rest flush on the base plate and must not come loose.
7.2
Attaching the dust bag
Use always the supplied dust bag in importance of your health (7) when you work with the
machine
8 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
8.1
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
8.2
Checking and replacing the carbon brushes
The carbon brushes must be checked on a regular basis.
In case of wear, replace both carbon brushes at the same time.
Mount the carbon brush holders.
After mounting new carbon brushes, let the machine run at no load for 15 minutes.
Use only the correct type of carbon brushes.
8.3
Connecting cable and mains plug
If the connecting cable (or mains plug) is damaged, it must be replaced. Replacement of the
connecting cable should only be carried out by a qualified specialist (qualified electrician).