POWXG1023
EN
Copyright © 2019 VARO
P a g e
|
13
www.varo.com
10.2
To start engine
▪
Activate the chain brake (move the hand guard forward and engage it) (Fig. 3b). Press
primer bulb till the primer bulb is filled with at least 1/3 of gasoline.
▪
To start the saw, push the engine switch (ON/OFF switch) to the ON (I) position (Fig. 9a).
▪
Pull out the choke (A) to the point where it latches in place (Fig. 9b).
▪
Place the saw on a firm and level surface. Hold the saw securely with your foot as
illustrated. Tug sharply on the starter 3-5 times.
When you hear ‘pa.pa.pa’-sound after
pulling starter 3-5times. You should open choke, then pull starter 2-3 times quickly, it is
easy to start engine. Watch the chain in case it runs (Fig. 9c).
▪
When engine turns, (Fig. 9d).
▪
Let the engine run for 10 seconds to warm up. Press the trigger (H) (choke will
automatically switch off) and put it into idle (Fig. 9e).
▪
Deactivate the chain brake.
If the engine does not start up, repeat the above steps.
10.3
Re-starting a warm engine
▪
Make sure the on/off switch is in the “I” position.
▪
Pull the starter rope rapidly 2 times. The engine should start.
10.4
To stop engine (Fig. 9f)
▪
Release trigger and allow engine to return to idle speed.
▪
Push the I/O (on/off) switch to o (off) to stop engine.
Note: for emergency stopping, simply activate chain brake and switch the
I/O (on/off) switch to O (off).
10.5
Chain brake operational test
Test the chain brake periodically to ensure proper function.
Perform a chain brake test prior to initial cutting, following extensive cutting, and definitely
following any chain brake service.
Test chain brake as follows:
▪
Place saw on a clear, firm, flat surface.
▪
Start engine.
▪
Grasp the rear handle (A) with your right hand (Fig. 10).
▪
With your left hand, hold the front handle (B) [not chain brake lever (C)] firmly (Fig. 10).
▪
Squeeze the throttle trigger to 1/3 throttle, then immediately activate the chain brake lever
(C) (Fig. 10).
Warning: activate the chain brake slowly and deliberately. Keep the chain
from touching anything; don t let the saw tip forward.
▪
Chain should stop abruptly. When it does, immediately release the throttle trigger.
Warning: if chain does not stop, turn engine off and take your unit to the
nearest authorized service center for service.
