POWX0760
EN
Copyright © 2014 VARO NV
P a g e
|
12
www.varo.com
9.2
Table height two-way set up
The table height can be set up in two ways, high or low table.
WARNING: Before falling down the tool backwards, always set the tool in
the Mitre saw mode and lock the tool head in the lowest position.
9.2.1
High table set up (Fig. 18)
To set up the tool with high table, proceed as follows.
Fall down the tool carefully BACKWARDS without fail while holding it with both hands.
Fix the 4 legs using a bolt, wing nut and the U-shaped customized washer.
9.2.2
Low table set up (Fig. 19)
Fold in the 4 legs. To do so :
Fall down the tool carefully BACKWARDS without fail while holding it with both hands.
untighten the wing nut of each leg seperatly until you can turn the leg 90° , aligned with
tabel. Then tigthen the wing nut again
Return the tool to the upright position.
9.3
Installing or removing saw blade
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or removing
the blade.
Use only the socket wrench provided to install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening of the hex bolt. This could cause an injury.
Move up the handle in the fully raised position. Press the shaft lock to lock the spindle, use
the socket wrench to loosen the hex bolt clockwise. (Fig. 20) Raise the blade guard A with
its lifting lever while pushing the lever nearby the handle to the left. With the blade guard A
raised, remove the hex bolt, outer flange and blade. (Fig. 21) To install the blade, mount it
carefully onto the spindle, making sure that the direction of the arrow on the surface of the
blade matches the direction of the arrow on the blade case. Install the outer flange and
hex bolt, and then use the socket wrench to tighten the hex bolt (lefthanded) securely
counterclockwise while pressing the shaft lock.
NOTE: When installing a saw blade, be sure to insert it between the blade
guard (7) at first and then raise it so that the blade is finally placed in the
blade guard. (Fig. 22 & 23)
CAUTION:
The ring 30 mm in outer diameter is factory-installed between the inner and outer flanges.
Return the lower blade guard (8) to its original position. Lower the handle to make sure
that the lower blade guards move properly. Make sure shaft lock has released spindle
before making cut.
9.4
Adjusting riving knife (fig 25,26 & 27)
There must be a clearance of about 5
–
6 mm between the riving knife and the blade teeth
when pushing riving knife toward the blade fully. Adjust the riving knife accordingly by first
loosening clamping nut by hand counterclockwise and then loosening hex bolt
counterclockwise with the hex socket wrench, and measuring the distance. After adjustment,
securely tighten the hex bolt and then the clamping nut clockwise. Always check to see that
the riving knife is secured and that the top blade guard works smoothly before cutting.
