POWE80060
EN
Copyright © 2017 VARO
P a g e
|
7
www.varo.com
Always wear safety goggles, hearing protection and if necessary other protective means,
such as working gloves, hard hat, etc.
7 ASSEMBLY
Before mounting an accessory, always unplug the tool.
7.1
Changing the attachment tools (Fig. 1)
The small accessory attachments such as the grinding stones or cutting discs may be
attached directly to the multi tool.
If required , these tools may also be attach to the flexible drive shaft.
7.2
Attaching small tools directly to the multi tool. (Fig. 2)
Turn the collet chuck grip (1) slightly while holding down the spindle lock button (3) until
the button engages.
Never press down on the spindle lock button while the tool is running.
If the collet chuck grip can not be loosened by hand, use the small spanner.
Change the attachment tool. Always tighten attachment tools as much as possible. Shafts
which extend out from the collet will cause wobbling.
Tighten the collet chuck grip. To replace the collet chuck, remove the collet chuck grip and
replace the chuck.
7.3
Accessories
7.3.1
Grinding bits (Fig. 3)
Use: sharpening, deburring, rust removal, shaping.
Tip: Clean and shape the grinding bits with the honing stone.
7.3.2
Grinding points (Fig. 4)
Use: For fine engraving of various materials.
Tip: Work on metals at a low speed and process as if it were hardwood.
Plastics must be processed at low speeds because of their tendency to melt during
processing.
Operating multi tool at a higher speed will lessen vibration.
7.3.3
Sander (Fig. 5)
Use: sanding , smoothing and shaping wood and fiberglass.
7.3.4
Grinding stone (Fig. 6)
Use: Cleaning and shaping grinding stones
7.3.5
Polishing discs (Fig. 7)
Use: Polishing metals and grinding stones.
Attention: Only polish with the sides of the disc. The head of the stone would will leave
scratches on the work piece.
7.3.6
Cutting disc (Fig. 8)
Use: Cutting or slitting bolts, screws , sheet metal, thin wood and plastic.
