POWE40050
EN
Copyright © 2017 VARO
P a g e
|
4
www.varo.com
If devices are provided for the connection of dust extraction and collection facilities, ensure
these are connected and properly used. Use of these devices can reduce dust related
hazards.
5.4
Power tool use and care
Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
Maintain power tools. Check for misalignment or sticking of moving parts, breakage of
parts and any other condition that may affect the power tool’s operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to stick and are easier to control.
Use the power tool, accessories and tool bits etc., in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed. Use of the power tool for operations
different from intended could lead to a hazardous situation.
5.5
Service
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
6 ADDITIONAL SAFETY-HINTS FOR SANDERS
Always wear safety-goggles and a dust-mask during your work with the finishing-sander.
Always secure the work piece by clamps or else to avoid slipping away.
Always keep the holes in the base plate clean from dust.
Always connect a vacuum cleaner to the attached adaptor during your work.
Take special care when sanding lead based paint:
All persons entering the work area must wear a mask specially designed for protection
against lead paint dust and fumes.
Children and pregnant women must not enter the work area.
Do not eat, drink or smoke in the work area.
Do not leave the tool running. Operate the tool only when hand-held.
Ventilate your work area adequately when you perform sanding operations.
Be sure that there are no cracks or breakage on the pad before use. Cracks or breakage
may cause a personal injury.
7 OPERATING INSTRUCTIONS
Do not sand plaster surfaces, (WARNING: In this case your guarantee
becomes void) this may clog the motor (brushes, ball bearings
,…).
7.1
Switching On-off (Fig. 1)
To start the machine, press the On/Off switch forward.
To switch the machine off, press the On/Off switch to the rear.
