VARO PowerPlus POWE10060, Руководство пользователя

Страница: 7 / 9

POWE10060
EN
Copyright © 2017 VARO NV
P a g e | 7
www.varo.com
Important! When hammer drilling you will require a low pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly. Re-sharpen or replace blunt drill bits.
Do not use the chuck with SDS connector in combination with the
hammer/hammer drill function!
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning

Keep the ventilation slots of the machine clean to prevent overheating of the engine.

Regularly clean the machine housing with a soft cloth, preferably after each use.

Keep the ventilation slots free from dust and dirt.

If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10 TECHNICAL DATA
Rated Voltage 220-240 V
Rated Frequency 50 Hz
Rated Power 900 W
Rotation speed 850 min
-1
Protection class II
Drill capacity concrete 26 mm
Drill capacity steel 13 mm
Drill capacity wood 40 mm
Impact rate 4100 min
-1
Cable length 2 m + VDE plug
Chuck type 13mm chuck and adapter
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
95 dB(A)
Acoustic power level LwA 106 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration) 17,8 m/s² K = 1,5 m/s²