VARO Powerplus POWDPG7553, Руководство пользователя

Страница: 13 / 23

POWDPG7553
EN
Copyright © 2021 VARO
P a g e | 13
www.varo.com
Note: if the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
8.2 Removal / insertion of battery
WARNING: Before making any adjustments ensure the tool is switched off
or remove the battery pack.

Hold the tool with one hand and the battery pack (31) with the other.

To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.

To remove: Press the battery release latch and pull the battery pack out at the same time.
8.3 Battery capacity indicator (fig. 1)
There are battery capacity indicators (34) on the battery pack, you can check the capacity
status of the battery if you squeeze the button (35). Before using the machine, please press
switch trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
 3 LED’s are litt: Battery fully charged
 2 LED’s are litt: Battery 60% charged

1 LED is litt: Battery almost discharged
9 ASSEMBLY
9.1 Blade assembly (Fig.2)
Assembling small blade on protective cover with 2pcs ST4*16 screws
9.2 Shaft assembly (Fig. 3)

Loosen the knob (8).

Pull the lock (9) outward and turn it left or right as far as it goes.

Slide the front tubular shaft onto the tubular shaft on the device housing.

Pull the lock (9) outward and turn it back to its original position.

Turn the front tubular shaft with a gentle rotating movement until the lock (9) clicks into
place in the bore on the front tubular shaft .

Fix the tubular shaft in place with the knob (8).