POWDPG7545
EN
Copyright © 2017 VARO
P a g e
|
8
www.varo.com
9 ASSEMBLY
The grass trimmer is supplied with some components not assembled. To assemble these
proceed as follows:
9.1
Mounting the guard
Fix the safety guard to the trimmer head making sure the sides are located into the
grooves on the trimmer head.
Secure the safety guard onto the trimmer head with the screws provided.
Remove the warning label sticker from the cutter blade immediately after mounting the
guard.
Caution! During this operation beware of the line cutter blade. You may be
wounded.
Caution! Never use the grass trimmer without the guard. It is vital for your
and other peoples’ safety and for the good working order of the trimmer.
The failure to observe this safety regulation is not only dangerous but also
annuls the guarantee terms.
9.2
Install edge guide
Spread edge guide arms apart, then push ends into holes on housing.
Use the edge guide to limit striking objects with the Line while trimming nearby.
Flip the edge guide up out of the way when not in use.
9.3
Height adjustment (Fig. 2)
To adjust the height, simply rotate and loosen the collar extension lock knob (5) as arrow 1
shown and to extend or retract the extension tube (6) as arrow 2 shown.
Tighten the extension lock knob (5) to lock the tube on the selected position.
9.4
Setting the auxiliary handle (Fig.3)
Squeeze the adjustment button of auxiliary handle (4).
Turn the auxiliary handle (3) until the most balanced and most comfortable position.
Then tighten the adjustment button of auxiliary handle (4) to the chosen position.
9.5
Adjustment the cutting angle (Fig.4)
Your Trimmers has a 2-positions cutting head. This setting allows you to work effectively at a
comfortable working angle. It can cut accurately around the flower beds, under bushes,
around trees and fence posts etc.
To change the angle, simply press the a head angle button (7) of the cutting head, to the
engine block to the desired position, then release the button.
Warning: remove the battery pack from the trimmers before handling
setting.
Warning: Always wear safety glasses. Never lean over the cutting head.
Stones or debris can bounce or be thrown into eyes and face and blind you
or serious injury. To use the machine, note the following points: Put on
heavy clothing and eye protection. Hold the front handle with one hand and
the auxiliary handle with the other hand. Store unit below the waist level.
Have the unit from right to the left so that residues are always projected on
the side opposite you. While avoiding bending over, keep the section
parallel to the ground wire (or perpendicular to trim edges) and prepared
the material to be cut (but not touching).
