POWDP6020
EN
Copyright © 2019 VARO
P a g e
|
5
www.varo.com
▪
Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators
and other polymer components may be damaged resulting in electrolyte leakage and/or
internal short circuiting leading to heat generation causing rupture or file. Moreover do not
dispose of the batteries in fire, explosion and/or intense burning may result.
▪
Under extreme conditions, battery leakage may occur. When you notice liquid on the
battery, proceed as follows:
−
Carefully wipe the liquid off using a cloth. Avoid skin contact.
−
In case of skin or eye contact, follow the instructions below:
✓
Immediately rinse with water. Neutralize with a mild acid such as lemon juice or
vinegar.
✓
In case of eye contact, rinse abundantly with clean water for at least 10 minutes.
Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do
not incinerate the battery.
7.2
Chargers
▪
Never attempt to charge non-rechargeable batteries.
▪
Have defective cords replaced immediately.
▪
Do not expose to water.
▪
Do not open the charger.
▪
Do not probe the charger.
▪
The charger is intended for indoor use only.
▪
Do not use an extension cord. Plug the charger directly into an electrical outlet.
▪
Use the charger only in an standard electrical outlet (100-240 V/50-60 Hz).
▪
To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting charger.
8 CHARGER
▪
Connect the charger to the power outlet socket. (Fig. 2)
8.1
Charging indication
▪
Solid green: ready to charge.
▪
Twinkling red: charging.
▪
Solid green and red: charged.
▪
Red light blink: hot or cool battery.
▪
Red and green lights blink: defective battery
8.2
Charging process
▪
Frequently monitor the charger and battery pack while connected.
▪
Unplug the charger and disconnect it from the battery pack when finished.
▪
Allow the battery pack to cool completely before using it.
▪
Store the charger and battery pack indoors, out or reach of children.
▪
Note: if battery is hot after continuous use in the tool, allow it to cool down to room
temperature before charging. This will extend the life of your batteries.
8.3
Battery capacity indicator
▪
There are battery capacity indicators (L1, L2 & L3) on the battery pack such as the Fig.3
shows, you can check the capacity status of the battery with squeezing the button (B).
▪
Before use the machine, please press switch trigger to check if the battery is full enough
for properly working.
▪
The statuses of three LED lights show the capacity level of the battery:
i. L1, L2 & L3 lights all lit: the battery is fully charged.
