VARO POWERPLUS GARDENPRO POWXG9504, Быстрый старт

Страница: 6 / 8

POWXG9504
EN
Copyright © 2017 VARO NV
P a g e | 6
www.varo.com
12 TROUBLESHOOTING
Incidents Causes Remedies
Pump does not start

No mains supply

Floater does not switch

Check mains supply

Bring floater in a higher
position
No flow

Inlet sieve is clogged

Pressure hose in bent

Clean inlet sieve water jet

Reset hose
Pump does not switch off

Floater cannot sink down

Place pump properly on shaft
ground
Insufficient flow

Inlet sieve is clogged

Reduced pumping capacity
by dirty and abrasive water

Clean inlet sieve

Clean pump and replace
worn-out parts
Pump switches off after
short operating period

Thermal cutout stops
pumps due to dirty water

Water too hot. Thermal-
cutout stops pump

Remove mains plug. Clean
pump and shaft

Make sure that a water tem-
perature of max. 35°C is not
exceed
13 STORAGE

Thoroughly clean the whole machine and its accessories.

Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.

Protect it from exposure to direct sunlight. Keep it in the dark, if possible.
 Don’t keep it in plastic bags to avoid humidity build-up.