POWXG3025
EN
Copyright © 2015 VARO
P a g e
|
10
www.varo.com
Hook the blade guard/combination guard onto the fitting on the shaft and secure with three
bolts. (Fig. 13)
Enter the guard extension guide in the slot of the combination guard. Then click the guard
extension into position on the guard with some claws. (Fig. 14)
The guard extension is removed easily using a screwdriver, see illustration. (Fig. 15)
11.1.5
Fitting a blade guard, grass blade and grass cutter
Hook the blade guard/combination guard onto the fitting on the shaft and secure with three
bolts. Use the recommended blade guard. See the Technical data section. (Fig. 16)
CAUTION! Ensure that the guard extension is removed.
Fit the top clamping plate (B) on the output shaft.
Turn the blade shaft until one of the holes in the top clamping plate aligns with the
corresponding hole in the top protecting cap.
Insert the locking pin (A) in the hole to lock the shaft.
Place the blade (C), bottom clamping plate (D) and bottom protecting cap (E) on the
output shaft. (Fig. 17)
Fit the nut (F). The nut must be tightened to a torque of 35-50 Nm. Use the socket
spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as
possible. To tighten the nut, turn the spanner in the opposite direction to the direction of
rotation (Caution! left-hand thread).
Pull out the locking pin after all installation process has been finished.
11.1.6
Fitting the trimmer guard and trimmer head (Fig. 18)
Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with
three bolts.
Fit the top clamping plate (B) on the output shaft.
Turn the blade shaft until one of the holes in the top clamping plate aligns with the
corresponding hole in the top protecting cap (C).
Insert the locking pin (A) in the hole to lock the shaft.
Screw on the trimmer head (D) in the opposite direction to the direction of rotation.
To dismantle, follow the instructions in the reverse order.
11.1.7
Fitting cutting head (Hedge trimmer) (Fig. 19)
Fit the cutting head (B) on the shaft tube (A) so that the screw hole on the cutting head is
aligned with the position hole (A1) on the shaft tube as shown. Then, tighten the lock screw (D)
and the position screw (C) securely.
Changing the hedge trimmer angle
Press the safety lever (E). Then press the lock lever (F), at the same time hold the grip (G)
and turn the cutting head to a desired ang
le (α).
11.1.8
Adjusting the harness (Fig. 20)
WARNING! When using the machine it must always be hooked securely to
the harness. Otherwise you will be unable to control the brush cutter safely
and this can result in injury to yourself or others. Never use a harness with
a defective quick release.
