POW60476
EN
Copyright © 2014 VARO
P a g e
|
12
www.varo.com
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A)
aw (Vibration)
7,5 m/s²
K = 1,5 m/s²
14 TRANSPORTATION
Turn off the motor during transportation of the tool.
During transportation, the protection should be fastened around the blade.
During transportation in a vehicle, the tool should be placed in such a way as to prevent
any fuel leakage.
If your appliance is to be transported, the fuel tank must be completely emptied.
When unloading your appliance from the vehicle after transportation, make sure that the
motor does not hit hard against the ground. This could cause severe damage to the fuel
tank.
15 STORAGE
Caution! Not following the following instructions may lead to deposits in
the carburetor and to permanent damage.
Execute all the recommendations concerning maintenance specified in the "Maintenance
and care" chapter.
Clean the engine outside surface, the shaft housing, the protective cover, and the string
attachment.
Drain fuel from the tank.
After fuel drainage, start the engine.
Let the engine run at idle until it stops. Asa result of that, no fuel will remain in the
carburetor.
Let the engine cool off (for approximately 5 minutes).
Remove the spark plug with the spark plug key.
Pour a little bit of 2-cycle engine oil into the combustion chamber. Pull the starter rope grip
a few times - oil will spread. Replace the spark plug.
Store the unit in a cool and dry place, which is remote from sources of fire like oil burners,
water heaters etc.
16 RESETTING IN OPERATION
Remove the spark plug and pull the starter rope fast, in order to remove oil from the
combustion chamber.
Clean the sparkplug or replace it, if necessary.
Prepare the unit for resetting in operation and fill the tank with the correct mixture of fuel
and oil (25:1).
