POWXG90410
EN
Copyright © 2018 VARO
P a g e
|
7
www.varo.com
This high pressure washer is in Europe only allowed to be connected with the
drinking water mains, when an appropriate mains backflow preventer has been
installed, Type BA according to EN 1717. The length of the hose between the
backflow preventer and the high pressure washer must be at least 10 metres to
absorb possible pressure peaks (min diameter ½ inch).
▪
As soon as water has flown through the BA valve, this water is not considered to be
drinking water any more.
IMPORTANT! Only use water without any impurities. If there is a risk of
sand particles in the inlet water (i.e. from your own well), an additional filter
should be mounted.
6.3
Safety devices
▪
The unloader valve can reduce pressure if it exceeds pre-set values.
▪
Locking device on trigger gun (9): The trigger gun (8) features a locking device (9). When
the knob is activated, the trigger gun (8) cannot be operated.
▪
A thermal sensor protects the motor against overloading. The machine will restart after a
few minutes when the thermal sensor has cooled.
7 ASSEMBLY
This section will explain in details how to make you high pressure washer ready for use.
7.1
Assembly of storage hook
Slide the storage hook into the holder.
7.2
Assembly of the gun (Fig. 1)
▪
Insert the adjustable spray nozzle (K) into the gun. Push and turn the adjustable nozzle
clockwise onto the gun (J) until hand tight to lock it in place. When the pieces are joined
properly, you cannot separate the two components by pulling straight out on the
adjustable nozzle. All attachments must be inserted into the gun for proper use.
7.3
Mounting of trolley handle (Fig. 2)
1.
Place the trolley handle on the machine
2.
Secure the handle with the 4 screws.
8 OPERATION
8.1
Connection of garden hose (Fig. 3)
▪
Before attaching the water inlet connector to the pressure washer remove the plastic cap.
▪
Attach the hose connector (with built-in filter) to pressure washer.
▪
Connect the garden hose with a standard quick coupling
8.2
Mounting of high pressure hose (Fig. 4)
1.
Attach the high pressure hose to the trigger gun and machine.
2.
Detach the high pressure hose by pressing the pawl (A) or button (B)
8.3
Mounting of lance and nozzle
1.
Push the lance into the trigger gun
2.
When inserted turn it. Caution: Make sure the lance is properly fixed to the gun
3.
Attach the nozzles. Push it powerful onto the lance. Check before activating the trigger
that the nozzle is properly fixed.
