VARISCO PSDrive 11, Инструкция по установке, эксплуатации и обслуживанию

Страница: 23 / 56

Fuses and circuit breakers
The control device is able to protect the motor from overload by means of digital control of the absorbed
current with reference to the set nominal current.
It is therefore, not necessary to install any other overload protection device between the inverter and the
motor.
Instead, it is necessary to install upstream of the device overcurrent and short-circuit protection devices
such as fuses and circuit breakers. These intervene in the event of failure of a component inside the
device.
Supply voltage Model Recommended fuse
gC
Recommended circuit breaker
ABB MCB S200
3 x 380 - 460 VAC PSDrive 11 10 S203-C10
3 x 380 - 460 VAC PSDrive 22 10 S203-C10
3 x 380 - 460 VAC PSDrive 40 16 S203-C16
3 x 380 - 460 VAC PSDrive 55 20 S203-C20
3 x 380 - 460 VAC PSDrive 75 25 S203-C25
3 x 380 - 460 VAC PSDrive 110 30 S203-C32
3 x 380 - 460 VAC PSDrive 150 35 S203-C40
3 x 380 - 460 VAC PSDrive 185 50 S203-C50
3 x 380 - 460 VAC PSDrive 220 63 S203-C63
Residual Current Devices (RCD)
For inverter devices with three-phase power supply, it is recommended to use RCD devices that are
sensitive to both alternating and direct current. The devices shown are:
• Type B, marked with the symbols
7.3. Connecting cables
WARNING
The connecting cables must comply with local regulations, have the appropriate cross-
section, and meet the requirements for voltage, current, and temperature.
7.3.1. Power cables
Model Maximum section
of the input cable
with earth
Maximum section
of the output cable
with earth
Cable tightening
torque [Nm]
Ground cable
tightening torque
PSDrive 11 4 x 2,5 mm
2
4 x 2,5 mm
2
- -
PSDrive 22 4 x 2,5 mm
2
4 x 2,5 mm
2
- -
PSDrive 40 4 x 2,5 mm
2
4 x 2,5 mm
2
- -
PSDrive 55 4 x 6 mm
2
4 x 6 mm
2
1 3
PSDrive 75 4 x 6 mm
2
4 x 6 mm
2
1 3
PSDrive 110 4 x 6 mm
2
4 x 6 mm
2
1,5 3
PSDrive 150 4 x 6 mm
2
4 x 6 mm
2
1,5 3
PSDrive 185 4 x 16 mm
2
4 x 16 mm
2
1,5 3
PSDrive 220 4 x 16 mm
2
4 x 16 mm
2
1,5 3
PSDrive
23