©2007 Brady Worldwide, Inc. All rights reserved.
Y643001 04/07
Step 3: Connect the peripheral devices.
Note: Drivers and utilities needed for VariQuest devices are preinstalled on the
DC1000. If you are connecting other devices, refer to the user’s guide for the
device you are connecting for instructions on installing any required drivers.
Step 4: connect the power cable.
Step 5: Replace the rear cover and turn on power to
the DC1000.
When you turn on power to the DC1000, the VariQuest Design Center software is
launched automatically. Refer to the VariQuest Design Center Software user’s
Guide for details about using the software with each of the VariQuest devices.
A. You can connect peripheral devices such as the VariQuest™ Poster Maker
3600, the VariQuest™ Cutout Maker 1800 and the VariQuest™ Awards
Maker 400 to any of the USB ports on the DC1000. The illustration below
shows an example connection.
VariQuest Awards
Maker 400
VariQuest Poster
Maker 3600
VariQuest Cutout
Maker 1800
Mouse
(optional)
Printer*
Keyboard (optional)
USB 1
USB 2
USB 3
USB 4
* For example, the ProImage®, PosterPrinter™ Plus, or XL3000 with parallel connection.
**The USB ports can be used to connect to any VariQuest peripheral device (such as the
Poster Maker 3600, PosterPrinter™ 3000, Awards Maker 400, and Cutout Maker 1800).
The USB ports can also be used to connect to a standard printer, which may be used to
print 8-1/2" x 11" proof copies of your posters.
Connect to any USB port**
A. Connect the power cable to the power supply located inside the DC1000
behind the rear cover.
B. Plug the power cable
into an electrical outlet.
A. Replace the rear cover
and close the rear cover
latches. (Reverse steps
B and C on the previous
page.)
B. Press the power button
on the underside of the
display panel. the power
LED turns on.
C. Adjust the display for the
best viewing angle.