4
2
1
m
aIntenanCe
:
The mixer
requires no maintenance (motor and bearings for the
mechanical parts are greased for life).
Safety device:
Check the function of the safety device regularly:
•
The motor
must stop when the rotary knobs is in neutral
position
(see fig. 3B)
.
If the safety device does not function, do
not use the mixer. Contact your dealer.
l
ISt
of
errorS
and
poSSIble
SolUtIonS
:
If the problem cannot be solved, contact
your dealer.
The mixer does not start:
Check that ...
•
The upper part of the mixer is in its down position.
•
The mixer is plugged in and connected to power.
•
The electrical power supply is correct.
•
The fuse in the cable plug
(fig.6, 1)
has not been burned.
If the fuse is defective, it can be replaced by the extra fuse
(fig.6, 2)
that is also available in the cable plug.
The mixer stops during work:
•
The mixer is overloaded due to too high speed or too
heavy loading. See the paragraph
“overloading”
.
In case of power failure set the rotary
button back to neutral position, and the
mixer can be started again.
The tool is stuck in the bayonet shaft:
This is normally due to insufficient cleaning or damaged hole
in the tool:
•
When the tool is stuck, do not force it free. Apply a little
oil and let this work a couple of minutes.
•
Turn the tool backwards and forwards until it can be re
-
moved.
unnormal noise:
Metallic noise ...
•
The tool is distorted and hits the bowl.
•
The bowl has been damaged or is not in its proper posi
-
tion.
m
oUntInG
of
aCCeSSorIeS
:
The mixer is equipped with an attachment hub with variable speed,
and with the possibility of attaching the following equipment:
•
Meat grinder , supplied with meat tray, stomper and set of
knives consisting of blade and plate 5/32”.
•
Vegetable slicer mounted with discs for shredding, grat-
ing and cube cutting.
For further information regarding ac-
cessories, please see the special sheets
following the accessories.
The mixer must always be disconnected
before mounting or dismantling of the
accessory.
Mounting of accessories (fig. 7):
•
Assemble the accessory in question.
•
Stop the mixer.
•
Turn the cover plate
C
away from the hole.
•
When mounting the pre-mounted accessory
a
, the shaft
B
is inserted into the attachment drive
D
of the mixer.
•
By turning the accessory until the pin
e
is pointing to-
wards the slot
g
a correct clutch is obtained.
•
The accessory is pushed as far into the attachment hub
D
as possible. (The pin
e
must be in the slot
g
, then the shaft
of the accessory is in a correct clutch with the attachment
drive).
•
The accessory is fastened by turning the knob
H
clock-
wise.
Dismantling of accessories (fig. 7):
•
Stop the mixer.
•
Turn the knob
H
counterclockwise until the locking screw
is free of the hole
F
.
•
Take out the accessory of the attachment hub, dismantle
and clean it.
Fig. 7 Mounting of accessories.
r
eCommended
SpeedS
for
attaChment
hUb
:
Fig. 6 Fuses in the cable plug.
