Systematic maintenance:
Part
Action
Frequency
Note
Safety guard
Check the safety of the safety guard:
Does the tool stop rotating (< 4 sec.)
when the guard is tilted/removed?
Regularly
I
f any malfunction,
please contact a technician
Emergency stop
Test the emergency stop: Does the
tool stop rotating (< 4 sec.) when the
emergency stop is activated?
Regularly
I
f any malfunction,
please contact a technician
Mixer head
The mixer head should only be lubri-
cated on repair, see the section
“Lu-
brication and grease types”
.
During repairs
The machine’s oth-
er moving parts
The moving parts that belong to the
bowl’s lifting mechanism all run in
maintenance-free plain bearings and
should not therefore be lubricated.
Never
Attachment drive
The rubber plug for covering the open-
ing of the attachment drive should be
on the machine and be intact.
Daily
The rubber plug must cover
the opening on the attachment
drive when the latter is not in use.
Cleaning
Follow the instructions in the section
“Cleaning”
Follow the instructions in
the section “Cleaning”
Lubrication and grease types:
Lubrication and other servicing may only be carried out by trained staff over 14 years of age.
The lid of the mixer may only be removed when the cable to the mains supply has been removed.
When repairs are made to the mixer head, the gear wheel and internal gear should be lubricated with
Molykote G-1502
FM
the needle bearings in the mixer head can also be lubricated with this type of grease.
If the machine is supplied with an attachment drive, the gear for the attachment drive should be lubricated with
Renolit
GreaseWay LiCa 80
.
Do not use any other grease types than those specified above.
Overloading:
The mixer must not be overloaded.
Possible overload situations:
•
Working with excessively tough and heavy dough
•
Mixer tool exceeding the recommended speed
•
Wrong mixer tool being used.
Larger lumps of fat or chilled ingredients must be reduced before they are placed in the bowl.
Overloading will cause the
VFD (variable frequency drive)
to stop the machine.
,
or
will be displayed in the timer field.
Follow the description under “
Procedure in case of overloading”
.
Procedure in case of overloading:
Spot the error code in the section
“Error codes and possible solutions”,
and follow the suggestion for a solution.
When done, remove the error code by pressing
.
The mixer can now be restarted by pressing
.
12
