![background image](http://html1.mh-extra.com/html/varian/969-8995/969-8995_instruction-manual_854645039.webp)
INSTRUCTIONS FOR USE
33/
50
87-901-004-01 (
B
)
GENERAL INFORMATION
This equipment is destined for professional use. Before oper-
ating the equipment, the user should read this instruction
manual and any other additional information supplied by Var-
ian. Varian declines any responsibility for non-compliance,
even partial, with these instructions, improper use by untrained
persons, unauthorized repairs of the equipment or use not
complying with specific national standards.
The TV81 Navigator controller is suitable for use with
Turbo-V81/T/M pumps. It is equipped with auxiliary connectors
that make it possible to power an additional fan, to control the
vent valve and for remote operation of the Navigator by a host
computer connected on a serial line (RS232 or RS485). The
following paragraphs contain all the information necessary to
guarantee operator safety when using the equipment.
For detailed information, refer to the "Technical Information"
appendix.
The following conventions are adopted in this manual:
!
WARNING!
Warning messages are intended to draw the operator’s atten-
tion to a particular procedure or practice which, if not followed
correctly, may cause serious injury.
CAUTION
Caution messages are displayed before procedures which, if
not followed, may cause damage to the equipment.
NOTE
The notes contain important information taken from the text.
STORAGE
When transporting and storing the pumps, the following envi-
ronmental conditions should not be exceeded:
−
temperature: from -20° to +70 °C
−
relative humidity: 0 - 95% (non-condensing)
PREPARATION FOR INSTALLATION
The TV81 Navigator is shipped in a special protective pack-
aging; in the case of damage during transport, contact your
local sales centre. Do not dispose of the packaging in the en-
vironment. The material is totally recyclable in accordance with
Directive 85/399/EEC on environmental protection.
INSTALLATION
Do not install or use the controller in an environment exposed
to atmospheric agents (rain, snow, ice), dust, aggressive
gases, or in explosive environments or those with a high fire
risk. During operation, the following environmental conditions
must be complied with:
−
temperature: from + 5 °C to +45 °C
−
relative humidity: 0 - 90% (non-condensing)
!
WARNING!
For user safety, the Turbo-V controller 969-8996 must be
powered by a 3-wire power cord (see orderable parts table)
and plug (internationally approved). Always use this power
cord and insert the plug in a socket with a suitable ground
connection to avoid electrical shock and to comply with EC
requirements . The high voltage developed inside the control-
ler can cause severe injury or death. Before installing or serv-
icing the unit, always disconnect it from the socket.
!
WARNING!
To avoid injury to personnel and damage to the equipment, if
the pump is lying on a table, make sure it is steady. Never
operate the Turbo-V pump if the pump inlet is not connected
to the system or blanked off.
CAUTION!
The TV81 Navigator belongs to the second installation (or
overvoltage) category of the EN 61010-1 standard. Therefore,
connect the device to a mains line that complies with the
above category.
The TV81 Navigator has Input/Output and serial communica-
tion connectors that must be connected to external circuits in
such a way that no live parts of electronic board are
accessible.
Make sure that the insulation of the device connected to the
TV81 Navigator is adequate even in the case of a single fault
as per the EN 61010-1 standard.
For installation of optional accessories, see "Technical
Information".
Содержание 969-8995
Страница 2: ...TV81 AG Navigator Controller 969 8995 969 8996...
Страница 3: ......
Страница 4: ......
Страница 42: ...TECHNICAL INFORMATION 36 50 87 901 004 01 B Outline 24 V 969 8995 Outline 969 8996...