TRIMMER-50
TRIMMER-60
13
Note
: In a new or cold engine, engine stalling may occur at the several first string
head drive starts. The phenomenon disappears after the engine has warmed up.
5.4
Machine travel
The machine is not equipped with the travel and it must be therefore pushed into the
engagement.
5.5
Machine stop
•
The string head drive will switch off when the horizontal bar on the handlebars is
released.
•
The engine will switch off when the lever is moved into the
STOP
position.
! Prior to performing any activities in the near vicinity of the machine, switch off
the engine and wait until the string head stops! Always switch the engine off before
leaving the machine.
! Don’t stop the running out string head by pressing it against the ground (e.g.
lifting the rear machine part by pulling on the handlebars).
! When the string head runs out, hold the handlebars firm so that the machine
could not move to the side due to the friction of support disk on the surface!
! Never let the engine running at maximum speed or idling with the string head
drive gear clutch switched off for a long time! Machine drive components (V-belt,
belt pulley, clutch pulley, etc.) might get damaged!
! In the case of any critical situation, release your hold on the handlebars
immediately. The horizontal bar will return to its zero position, the string head
will come to a stop (while the engine is still running at adjusted rotations; this is
why it is to be switched off by pushing the accelerator lever into the STOP position
as soon as possible!)
5.6
Working with the machine
5.6.1
Mowing grass stands
! Prior to the machine use, the stand must be cleared of solid bodies such as
stones, wires, loose construction debris, etc., which could be flung or might
otherwise damage the machine. Should these be impossible to remove, pass the
places by in order to prevent impacts on the working tool and its premature wear
or destruction.
! Mowing engagement width has to be at all times accommodated to the stand
density!