Vari Liza DS-520, Инструкция по применению Инструкция по применению, Страница: 5 / 31

DS-520 Líza
DS-520H Líza
5
3 Operation safety.
3.1 Safety regulations.
,
This international symbol indicates important messages concerning safety. When you see
the symbol, be aware of a possible injury to yourself or to other persons and read
attached instructions carefully.
,
The machine operator must be over 18 years of age. He (she) is obliged to get familiar
with the instructions for use of the machine and is supposed to be informed of the
general principles of work safety.
,
Prior to each employment of the machine, check its parts (cutting blades and their
clamping or casing in particular) for possible wear, damage or loosening. Defects must
be rectified without any delay. Repairs are to be made only with original spare parts.
,
Prior to carrying out any activities in the near vicinity of the machine or prior to moving
the machine to another place switch the engine off and wait until the mowing disk stops
moving! Before leaving the machine alone, switch off the engine!
,
Do not stop the running out mowing disk by pushing it against the ground (e.g. by lifting
the rear part of the machine by holding on handlebars).
,
When the mowing disk runs out, hold the handlebars firm so that no side movement of
the machine can occur due to support plate friction on the ground surface!
,
Never let the engine running at maximum speed or idling for a long time with the
mowing disk drive clutch switched off! Components of the machine drive (V-belt, belt
pulley, clutch pulley, etc.) might get damaged!
,
Before using the machine, the sward to be cut must be cleared of solid bodies such as
stones, wires, loose construction debris, etc., which could be flinging up or which might
damage the machine. If these cannot be removed, don’t work the places.
,
Adhere to basic safety regulations when working with the machine. The machine is
equipped with the rotating working blades. Maximum circumferential speed is 64.2
m.sec
-1
. Therefore, see to it that other persons move at a safe distance from the machine
when it is in operation with regard to a possibility of mown sward or solid objects flying
away!
,
With respect to exceeded recommended values of noise and vibrations, you are warned
to observe the following instructions when working with the machine:
a) Protect your hearing by using suitable protective aids specified in
ČSN EN 352 -1
(shell ear protectors) or
ČSN EN 352
-2 (plug ear protectors). Require the aids
from your dealer.