Surround
The
LED strip
is only suitable for installation in dry
indoor rooms.
Risk of electric shock!
Be sure to have a professional electrician complete
in stallation. There is no warranty coverage for any lights
installed without observing european safety directives.
Caution!
Only connect the
LED strip to a suitable
power supply (24 V DC).
Only operate when completely unrolled.
Connect
LED strips in parallel.
DELIVERY INCLUDES:
1 x 5 metre
LED strip
5 x in-feed connectors
1 x direct connector
TECHNICAL DATA:
Power supply 24 V power supply with constant
output voltage
Power 115.2 W
Current strength 4.8 A
Radiation angle 270°
Quantity LED 1440
Length maximum 5 metres per connection
Dimensions 5000 x 10 x 2.5 mm
Bending diameter 40 mm
Compliant with the applicable
european CE directives
Safety class 3 - low voltage protection
Very light - profile necessary
The
LED strip needs an
additional cooling element and
sufficing air ventilation.
Suitable for indoor use only
G
G
Figure 1
Figure 2
example figure
example figure
Surround_BA_PHF38ff_12/2022
With in-feed connector:
To connect a
LED strip to a power supply, use
a in-feed connector.
1.
Do not
remove the protection film at the connection position.
2. Open the shutter of the direct / in-feed connector
(Fig. 2+3).
3
.
Connect the in-feed connector to the end of the
LED strip (observe polarity) and close the fastener
(Fig. 2+3).
Caution!
With soldered connections note that the soldering
tem
perature is 260° C and the soldering duration a
maximum of 10 seconds per soldering point.
DISPOSAL:
Dispose of electrical and electronic equipment in an
environmentally friendly manner. Please contact your local
council for further information.
INSTALLATION:
Risk of electric shock!
Switch off voltage prior to installation. Ensure that voltage
cannot be accidentally switched on again.
Caution!
On conducting surfaces, place an insulation layer between the
LED strip and surface. Surfaces must be flat, free
of dust, grease and dry.
1. Prepare surface.
2. Shorten
LED strip if necessary (Fig. 1).
3. Peel off adhesive film and gently press on
LED strip, do not press directly on the LEDs.
4. Connect
LED strip to power supply.
SHORTENING THE LED STRIP:
Risk of electric shock!
Always disconnect the mains plug before shortening.
LED strip can be separated in each case after
fourteen LEDs (50 mm)
(Fig. 1).
Separate the
LED strip at the marked position.
For a tightly assembled LED strip is a micro side cutter or an
optional cutter required.
CONNECTING LED STRIP:
With direct connector:
To connect two
LED strip together, use a direct
connector.
Figure 3
example figure
Carl-Zeiss-Str. 15
28857 Syke
rutec
Projekt
