NEEST-03
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
T: 00352/26908036 – F: 00352/26908040
SAFETY INSTRUCTIONS
Warning!
•
Ensure that the engine support is in good working order. take action for immediate repair or
replacement of damaged parts. Use genuine parts only. The use of unauthorised parts may be
dangerous and will invalidate the warranty.
•
Locate the vehicle in a suitable, well lit work area.
•
Keep work area clean and tidy and free from unrelated materials.
•
Ensure the vehicle handbrake is engaged and the engine/motor is switched off.
•
Ensure all non-essential persons keep a safe distance whilst the engine support is in use.
•
DO NOT use the engine support if damaged.
•
DO NOT allow untrained persons to operate the engine support.
•
DO NOT use the engine support for purposes other than that for which it is designed.
•
DO NOT exceed the rated capacity of the engine support.
•
When not in use, store engine support in a safe, dry, childproof area.
SPECIFICATIONS
Designed to support and accurately position engines during maintenance operations such as replacing anti-
vibration mountings and certain body panels. Also used as an aid for the removal of gearboxes and
transmissions. Beam supported on rubber feet and fine adjustment control is obtained by using double
screw/hook mechanisms. supplied with two short lengths of chain.
NEEST-03 Technical Specifications:
•
Maximum capacity
500kg
•
Maximum Width
1605mm
•
Minimum Width
605mm
•
screw travel
260mm
•
Weight
13.96kg
ASSEMBLY INSTRUCTIONS
Note: numbers in brackets refer to item numbers shown in fig.1
•
Insert a foot (5) into the slot in the standing block (4). Align the holes in the two components and join
them together using an M10 x 30 bolt (10).
•
Place a large washer (8) over the upstanding rod on the standing block (4) and insert the rod through
the slot in the main support guide from underneath. Place a large washer (7) over the thread on top of
the rod and secure the assembly to the main support guide by screwing on a grip knob (6) as shown in
fig.1. Assemble the other foot/standing block and fix the assembly to the other end of the main guide
beam in the same way.
•
Drop a large washer (8) over adjustable screw (3) and screw lift handle (2) onto the top of the
adjustable screw. Screw the lift handle approximately half way down the threads. Make up the second
adjustable screw in the same way and have both assemblies ready to drop through the slot in the main
guide beam after the beam has been placed over the engine bay.
•
The chains should also be attached when the guide beam is mounted over the engine.
