INSTRUCTION MANUAL
·
MIG SERIES
10
6.3.2 Installation sketch map
MIG 160
J35
NO GAS
GAS
gas hose
sw
itc
hin
g b
ox
6.3.3 Operation
(1) After installation according to the above steps, turn the power switch on the back panel to
“ON” position, then the power LED turns on, and the fan works. Open the gas cylinder
valve, and adjust the flow meter to the desired position.
(2) Turn the conversion switch on the front panel to “Gas shielded arc welding” position, and
adjust the welding voltage adjustment knob and wire feeding speed adjustment knob
according to practical needs to get the desired welding voltage and welding current.
(3) Press the welding torch switch, and welding can be carried out.
(4) Adjust the burnback time potentiometer on the clapboard to get the desired length of
welding wire stretching into the contact tip after welding.
(5) Cut off the gas 1s after the arc is stopped.
6.4.1 Installation of self shielded arc welding
(1) Plug the welding torch into the output socket “
” on the front panel, and tighten it. Thread
the wire into the torch manually.
(2) Insert the earth cable plug into the positive socket “1” on the front panel, and tighten it
clockwise.
(3) Insert the fast plug on the wire feeder into the output socket
“
NO GAS
”
on the clapboard,
and tighten it clockwise.
(4) Fix the welding wire coil to the rack axis on the wire feeder; make sure the hole of the wire
feeding wheel matches well with the bolt on the rack axis and the welding wire diameter.
