Connecting the Suction/Injection hose (21)
Pull the accessories socket door (16) wide open and plug the
quick connection for the hose (21) into the socket on the front
of the appliance; push the quick connection in as far as it will
go.
Close the accessories socket door (16) against the body of
the quick connection and ensure that the two parts latch onto
each other.
(Fig. 10)
Electrical connection.
The connection of the steam/vacuum appliance to the mains
supply must be in accordance with current regulations (for
Italy, refer to Law no. 46/90).
Check that the main voltage on the electric system matches
the voltage the appliance has been engineered to run at.
Electrical data can be found on the appliance identification
plate
(Fig. 11)
&
The lead (4) must be protected against inadvertent
pinching.
Non-compliance with the instructions above relieves
the manufacturer from any and all responsibilities
and is classified as careless use of the appliance.
STARTING THE APPLIANCE STEAM/VACUUM
FUNCTION
Make sure the button (18) and switches (19, 20) on the handle (21) are OFF. - Press the main switch
(10) und the boiler switch (12) to turn the appliance and the boiler on. If more power is needed and in
order to accelerate the heating process, press the boiler switch super power (11).
- W ait for the boiler to reach the appropriate operating pressure. W hen the green light (8) illuminates,
the appliance is ready for use.
- Select the desired steam level with the appropriate control hand wheel (14).
Fig. 10
NOTE
Vacuum and steam power can be changed during machine operation.
Under normal operating conditions, an illuminated green warning light will indicate that pressure in the
boiler is within normal values; however, continual steam delivery causes pressure to decrease slightly;
in this case, the warning light will switch off automatically until the operating pressure value is reached
again. Even in this condition, you may safely continue with your cleaning job, since resistances in the
appliance have been proportioned to provide immediate reinstatement of the operating pressure.
Turning on the appliance in the vacuum function:
Ensure that the switch (19) on the handle (21 ) is OFF.
Press the main switch (10) to switch ON the appliance in vacuum-cleaning mode. Now the appliance is
ready for use.
Fig.
11
How to operate the appliance:
Before using the appliance, fit the desired tool to the hose handle (21 ). Once the tool is installed, use
the controls on the handle to operate the appliance as fit.
Using the controls on the handle, you can:
- deliver steam, by pressing the red button (18);
- vacuum, by pressing the white button (16);
- deliver detergent or water, by pressing the water/detergent delivery switch (20);
- deliver steam and vacuum at the same time, by pressing red button (18) and blue switch (19).
- deliver steam and detergent at the same time, by pressing red button (18) and switch (20);
- deliver water/detergent and vacuum at the same time, by pressing switch (20) and blue switch (19).
To stop the function in use, simply turn off the relevant switch.
GENERAL OPERATING INSTRUCTIONS
1.
Using any electrical appliance requires the observance of a number of fundamental rules. Here
is a list of these rules:
·
Do not touch the appliance with wet hands or feet
·
do not use the appliance when bare-footed or wearing inappropriate clothes
• Do
not tug at the lead or at the appliance to disconnect the plug from the socket
2. The appliance may not be used by children, teen-agers or individuals unfit for the purpose (e.g.: in a
drunken state, etc)
3.
Do not let people near the area of operation of the appliance
4.
Keep the appliance dry; do not use in wet weather.
5.
Do not obstruct the openings or slots provided for ventilation or heat discharge.
6. In case of failure and/or malfunction, switch off the appliance but do not tamper with it.
Contact one of our service centres instead.
7 Do not use the appliance when the supply lead is damaged; to replace it, contact our service
centres only.
8. Do not wash the appliance with water jets.
8
NOTE
If water or detergent in the tanks (9) and (15) run out, you will be alerted by a buzzer.
NOTE
When the cleaning job is completed, it is advised to leave the vacuum function enabled for a few
seconds. This will a low the recovery of any residual water and steam that are left in the ducts.
9
