3
and all connected devices.
Proceed with caution. Danger to life!
Switch off the computer in which the product is to be installed and all
connected devices. Disconnect all devices from the mains voltage and
pull out the mains power supply plug! Just turning off at the on/off switch
is not enough!
• Open your computer’s housing and carefully remove the cover.
• Look for a free 3.5“ installation slot and remove the slot cover.
Often there is a metal shielding behind it, which has to be removed first.
With some casings, you have to unscrew this, with others you have to
break it out carefully.
Depending on the casing, you may have to
remove the entire front cover first.
• Depending on the existing computer housing, the slot cover can easily
be replaced by another one.
• Slide the plug-in unit into the computer housing and screw it tightly.
• Connect the SATA plug connector with a free SATA connection of your
motherboard. Please also note the operating instructions of the
motherboard
• Connect the 5-pin USB plug to an internal USB port on the
motherboard. It is imperative to observe the correct orientation (see
operating instructions for the motherboard) since a wrong connection
may damage both the motherboard and the electronics of the 3.5“plug-in
