Installation Guide
Information in this document is subject to change without notice.
Reproduction of these materials in any manner whatsoever without written permission is strictly forbidden.
Printed in China
Printed on Recycled Paper.
Copyright © 2014 Vantec Thermal Technologies. All Right Reserved. | All Registered Trademarks Belong To Their Respective Companies.
Model: UGT-MST100
/
MRK-MST250
MRK-MST250/UGT-MST100
Changing screws mount for other size mSATA card (27mm or 70mm card).
Pull side wall back slightly to unlock latch holding PCB and
lift the PCB out of the housing for all 4 locking latch.
1.
PCB lock by latch
on side wall.
Pull side wall back
slightly to unlock
latch holding PCB.
Look on the back of the Printed Circuit(PCB)
for the mSATA card mount (at 50mm position).
2.
3.
Remove the screws and washer holding the mSATA
card mount.
4.
27mm
50mm
70mm
Move the card mount to the right position that
matches your mSATA card and secure back the
screws and washer that holds the card mount.
5.
Secure the card mount back to the correct position using the
screws remove in step #3.
Attach mSATA Device by inserting the mSATA card and securing the two screws to hold the mSATA card in place.
6.
