Vante 4160, Инструкция по эксплуатации

Страница: 27 / 40

Vante ® Model 4160
19
NOTE: As soon as a run cycle is initiated, the sealing head latch locks the sealing head
shut. The latch releases the sealing head once the temperature cools to the safe
level.
2.11. Teflon Fiberglass Adhesive Barriers
2.11.1. A set of Teflon fiberglass adhesive barriers is included with the sealing head.
The barriers can be used to prevent the tubing material from sticking to the
sealing head plates during the sealing process. Organizations are responsible
for validating the sealing process with or without the Teflon fiberglass
adhesive barriers.
Contact Vante to order replacement Teflon fiberglass adhesive barriers.
2.11.2. To change or apply the barrier, first remove power from the system. Ensure
that the sealing head plates are at room temperature before applying the
barrier.
2.11.3. Remove the backing from the adhesive side of the barrier.
2.11.4. Apply the adhesive side of the barrier to the clean, dry plate.
2.11.5. Smooth the barrier onto the plate. Repeat this process on the other plate. See
Figure 2.9.
Figure 2.9 Teflon fiberglass adhesive barrier application
2.11.6. To remove the barrier, simply lift a corner of the barrier and peel it off the
plate. Avoid scratching the surface of the plate while removing the barrier.
NOTE: Do not remove the barrier unless replacing it due to wear. The adhesive barrier is
not re-usable; it will not stick to the plate once it is removed.