Van's Aircraft RV-12, Руководство по обслуживанию

Страница: 159 / 217

Rev.5
13-7
2. Label, then disconnect the electrical connections attached to the component, if
applicable.
3. Disconnect the fuel line(s) attached to the component, if applicable.
4. Remove the attaching hardware and component.
I
NSTALLATION
1. Installation procedure is reverse of the removal procedure.
SERVICE SCHEDULE PROCEDURES
▲ W
ARNING
: A
LWAYS HAVE AN APPROPRIATE FIRE EXTINGUISHER READILY AVAILABLE
.
G
ASCOLATOR CLEANING
Tools 3/16 Standard screwdriver
¼” drive socket extension, ¼”
socket, flat blade screw bit
Safety wire pliers
Fuel catch container
Expendable Safety wire
Replaceable Gas-5 Screen
Gas-5 O-ring gasket
Service Rating Preventative
Minimum Certification Owner and SPC, LSA-RM or A&P
Additional References KAI
1. Remove the engine cowling. (12-4)
2. Move the fuel valve to the OFF position.
3. Remove the fuel quick-drain to drain the existing fuel from the gascolator bowl.
4. Remove the safety wire and screws (4) from around the gascolator bowl. (Note:
The inboard aft screw can be accessed through the hole provide in the
bottom plate of the nose gear assembly by using a ¼” drive socket
extension, a ¼” socket, and a screw bit inserted in the socket).
5. Remove the collar and the gascolator bowl. (Note: Have a container available
to catch any spillage of fuel that still remains in the gascolator and fuel
lines).
6. Use a small pointed tool to lift the edge of the filter screen and remove it for
cleaning.
I
NSTALLATION
:
1. Installation procedure is reverse of the removal procedure.