Vanraam OPair3, Руководство пользователя

Страница: 30 / 38

User manual
OPair3 17.04
29
Adjustments by dealer
The correct tension of the chains
Several chains are present on the tricycle. These must have enough room for
movement. Without any real effort, the chain must be able to be moved about half a
centimetre up and down.
In order to keep tension on the chain, the rear
wheel axis can be adjusted. Follow the
instructions below:
1. Slightly loosen the nuts on the rear
wheel axis, allowing the rear wheel to
move back and forth.
2. Tighten the nuts on the two chain
tensioners, making the rear wheel move
backwards and tightening the chain. Do
this in such a way that the chain has
some room to move, as previously
indicated.
3. At the same time, make sure the wheel
is straight and located in the middle of
the frame. Not to the left or right. See
figure [A].
4. Lightly tighten the nuts of the rear wheel
axis.
5. Make sure the tension on the chain is
adequate and that the wheel is attached
straight to the frame.
6. Now firmly tighten the nuts.
Setting the steering
In order to realise optimal steering behaviour
and minimal tyre wear, the steering must be
set correctly.
1. Loosen the left and right nuts of the
steering shaft [A].
Please note! This is a nut with a left wire
and a nut with a right wire.
2. Subsequently turn the steering shaft to
adjust the tracking of the wheels. The
wheels must be set parallel.
3. Tighten the nuts of the steering shaft
again.
[A]
1.
2.
2.
[A]