VANPOWERS URBANEASE Series, Руководство пользователя, Страница: 23 / 61

Loosen the four screws on the handlebar
clamp in a counterclockwise direction
with a 4 mm Allen key, then remove the
screws and front cover.
02 Install and adjust the handlebars
STEP ONE
Place the handlebar in the center of the stem clamp when
the user is on the saddle and make sure it is oriented correct-
ly. The gear shift should be on the right side and the control
buttons on the left. Reinstall the front cover and tighten the
screws securely, but not completely.
STEP TWO
Adjust the handlebars:
Push the handlebars left and right to center them; rotate them
slightly so that the brake levers are angled downwards. Then,
gradually tighten the screws in an A-B-C-D sequence.
Note that it is not necessary to fully lock the handlebar in place
at this time. After adjusting the stem height and handlebar
angle on
page 30 , you can retighten the handlebar screws in
sequence as shown in the figure.
STEP THREE
21
4mm
A
B
C
D
4mm