V-SIX
120V
25799 Jefferson Ave. Murrieta, CA 92562
1-800-VANIMAN (826-4626)
www.vaniman.com
V-SIX 08/20
Page 2
8. The unit is designed to provide suction to six stations simultaneously. The plumbing layout is critical
for maximum performance, so consult with a Vaniman engineer for your plumbing sizes and layout
assistance.
9. The inlet plate located on the back of the unit incorporates a vacuum relief valve calibrated at the
Manufacturer. The V-Six is a high suction dust collector and attempting to adjust this without first
consulting the manuafcturer may cause damage to the unit.
10. When moving the unit, ensure that the power cord, remote cord, compressed air connections, and
plumbing are disconnected from the unit. Do not attempt to lift the unit by yourself and always use a
dolly, hand truck, and/or any other appropriate tools needed to prevent user injury. Always move the
unit in the upright position to prevent the unit from falling over.
MAINTENANCE
1.
Filter Cartridge
- The filter cartridge should be visually inspected for wear on a routine basis. Before
inspecting the filter cartridge, turn the unit off, then press the Clean button to activate the Air Blast.
DO NOT
press the button when the front door is open.
To maintain the highest level of filtration
and prevent motor damage, the manufacturer recommends replacing the filter every six months for
average usage. When dust begins to pass through the unit or the filter is visibly frayed or worn, it
should be replaced immediately.
2.
Dust Bin
- The Dust Bin will hold approximately three gallons of debris so the frequency of emptying
the bin will vary. To empty, open the front door and slide the dust bin out of its housing located at the
bottom of the unit. Each time it is emptied, be sure the wing nut on the bottom of the filter is secure.
3.
Circuit Breaker
- If the unit has an internal electrical problem or the power lines suffered an abnor
-
mal surge in power, the Circuit Breaker may trip. Correct the cause of the problem, then reset the
Circuit Breaker by pushing the breaker reset on the back of the unit until it clicks.
4.
Thermal Protection
- The high speed turbine drive system in the unit is protected against overload
and overheating. In the event that the unit turns off during operation, disconnect the cord, wait 5-15
minutes for the unit to cool down, then re-connect the power. Overheating could be caused by inad
-
equate ventilation. If the unit is in an enclosed space, increase air circulation or ventilation and retry.
RECOMMENDED USAGE
1. Two to six work stations. Dust collection of all dry materials.
2. The unit may be used alone or in conjunction with a Vaniman Accumulator pre-filter for every two
stations. The Accumulator will trap 90 - 95% of the dust in the collection trap before it reaches the
unit and will capture 99.9% of all metals.
Large Accumulator P/N VMC-A300, XL Accumulator
P/N 10509
3. The unit is NOT RECOMMENDED or warranted for use in moist or wet environments or to collect
wet or moist material. Doing so will immediately void the warranty.
