PURE BREEZE FX
FUME EXTRACTOR
25799 Jefferson Ave. ● Murrieta, CA 92562 ● 1-800-VANIMAN (826-4626) ● www.vaniman.com ● [email protected]
10380-12/21-PAGE 3
5. While the unit is
Off
, plug the black foot remote tube into the round black port labeled “Remote” on the
unit. To use the foot remote instead of the
On/Off
switch for sanitary purposes, leave the
On/Off
switch
on the side of the unit in the
Off
position. Test the remote function by pressing on the round bellows to
turn it
On
; press it again to turn it
Off
.
NOTE:
If using the foot remote to turn the unit
On
, you MUST
use the foot remote to turn the unit
Off
as well. Once the foot remote air switch has been activated by
the foot remote, the
On/Off
switch will not turn the unit
Off
, only the foot switch will.
FILTER REPLACEMENT INSTRUCTIONS
It is recommended that you replace the HEPA Filter when it becomes excessively dirty, or every 6-12
months. Replace the Charcoal Odor Filter when its effectiveness has noticably decreased.
1. Turn off the unit.
2. Remove the four thumb screws on the front of unit and set aside for later use.
3. Remove the panel to expose the HEPA and Charcoal Filter
4. Slide the Charcoal Filter out first, then the HEPA filter by pulling on the tab. Once removed, properly
dispose of the dirty filters.
5. Remove any packaging from the replacement HEPA and Charcoal Filter. Carefully align the HEPA
filter frame with the outer walls of the unit, sit the filter onto the guide ledge, and slide until the filter
stops. Once the HEPA filter is installed, carefully place the replacement Charcoal Filter on top of the
HEPA filter.
6. Put the front panel back on the unit and secure with thumb screws.
MAINTENANCE
1. Circuit Breaker
- The unit is protected by a circuit breaker on the left side of the unit. In the unlikely
event there is an overload condition the breaker may trip. If this happens reset the breaker by pushing
on the white button until it clicks into place.
2. Motor Brushes
- This long life motor does not have replaceable brushes. Replacement motors can
be ordered as P/N 97041.
RECOMMENDED USE
The Pure Breeze FX Fume Extractor is designed for use in collecting toxic or odorous fumes and should
not be used for collection of large particulates or wet substances. For an exhaustive list of chemicals
compounds that are best filtered with this unit, please visit the Pure Breeze FX Fume Extractor page at
Vaniman.com.