http://www.51082245.com
SGT-600 USER’S MANUAL
REV 1
26
3.6.2. Saving Test Results to a Test Record
After performing a test, the user is presented the option to save the test results to the unit’s
Flash EEPROM or to a USB Flash drive. If the test results are not saved immediately after
performing a test, they will still remain in the working memory and can be saved later, as long
as a new test has not been performed and the unit has not been turned off. Follow the steps
below to save the test results from the working memory to a test record (the following
procedure can also be used to re-save a restored test record to a new memory location or to a
USB Flash Drive):
a.
Perform a test or restore a test record to the working memory (see section 3.6.3 and
3.6.4), and then start from the “START-UP” menu:
Press the
[2]
key (
SETUP
).
b.
The following screen will be displayed:
Press the
[3]
key (
SAVE/RESTORE RECORD
)
c.
The following screen will be displayed:
NOTE
Option 5 (
COPY TO THUMB DRIVE
) will be listed only if a USB Flash drive is
connected to the SGT-600.
Press the
[2]
key (
SAVE RECORD
).
1.
RESTORE RECORD
2.
SAVE RECORD
3.
RECORD DIRECTORY
4.
ERASE RECORD
5.
COPY to THUMB DRIVE
1.
RECORD ID
2.
REVIEW RECORD
3.
SAVE/RESTORE RECORD
4.
set time
5.
set language
6.
CAL NOTICE ON/OFF
1.RUN TEST
2.SETUP
time: 10:11:12 23
°
C
date: 04/01/15 73
°
F
