1) PLACE THE 2 GANG RING INTO THE CHOSEN LOCATION ON THE WALL BY CUTTING THE DRYWALL.
PLEASE BE SURE THE AREA IS FREE OF OBSTRUCTIONS AND YOU CAN RUN WIRES FROM THE LOCATION
TO SPEAKERS, POWER SUPPLY AND OTHER CONNECTIONS.
2) LOCATE THE TWO SCREWS AT THE BACK OF THE VAIL CAST. YOU WILL BE REMOVING THESE SCREWS
AND THE RESECURING THEM WITH THE VAIL CAST BRACKET IN PLACE.
3) WITH THE BOTTOM TABS SECURED LOCATE THE OPENINGS AT THE TOP OF THE VAIL CAST THAT ALIGN
WITH THE UPPER TABS. YOU WILL SCREW THE TABS INTO PLACE WITH THE TWO PROVIDED SCREWS.
4) YOU CAN NOW SLIDE THE ASSEMBLY OF THE VAIL CAST AND BRACKET INTO THE 2 GANG MOUNTING
RING YOU HAVE INSTALLED. BE SURE TO MAKE ALL CONNECTIONS TO THE BACK OF THE VAIL CAST
FIRST. ONCE IT IS IN PLACE IT SHOULD ALIGN WITH THE SCREW HOLES ON THE LOW VOLTAGE RING.
USE THE REMAINING 4 SCREWS TO SECURE THE BRACKET TO THE RING. DO NOT OVERTIGHTENED AS
THIS MAY CAUSE ALIGNMENT ISSUES WITH THE SCREWLESS PLATE. ONCE THE SCREWS ARE IN PLACE
SNAP THE SCREW-LESS PLATE INTO PLACE. IF YOU WISH TO KEEP THE VAIL CAST CLEAN DURING ANY
REMAINING CONSTRUCTION WORK YOU CAN LEAVE THE PLASTIC FILM ATTACHED TO THE PLATE IN
PLACE. THIS WILL KEEP THE VAIL CAST AND PLATE CLEAN.
MOUNTING VAIL CAST INTO THE WALL
Remove & Save for Mounting of Bracket
Place Bracket onto the VAIL CAST so that the bottom holes align
with the screw holes and resecure the screws in place
Use two Screws
to Secure
the Upper
Tabs in Place
Once Lower Tabs
are Secured Align
Upper Tabs with
Openings
Iahg^3!1//"1,-&/,+*
>fZbe3bg_h9oZg`nZk]]rgZfb\l'\hf
ooo&nYf_mYj\\qfYea[k&[ge
