V&P Scientific, Inc.
8
Technical Note 104A
SAFETY PRECAUTIONS
The use of motor controls, like that of all utilization of concentrated power, is potentially hazardous.
The degree of hazard can be greatly reduced by proper design, selection, installation, and use, but all
hazards cannot be completely eliminated.
The following safety precautions must be observed during all phases of installation, operation, service,
and repair of this motor control product. Failure to comply with these precautions or with specific
warnings elsewhere in this manual violates safety standards of design, manufacture and intended use
of the products. V&P Scientif
ic assumes no liability for the customer’s failure to comply with safety
requirements and practices.
WARNING
To avoid personnel injury caused by electrical shock, do not
remove the motor cover when the power is ON.
CAUTION
Do not disconnect motor during operation. Otherwise, over-
current breakdown may result.
WARRANTY
V&P Scientific, Inc. warrants this product to be free from defects in material and workmanship when
used under normal laboratory conditions for one year. This warranty begins from the date of delivery
by V&P Scientific.
In the event this product fails under normal laboratory conditions within the specified period of time
because of a defect in material or workmanship, V&P Scientific will, at its option, repair or replace the
product. Damage to the product caused by user negligence is not covered.
Please keep the special shipping carton in case the unit needs to be shipped back to V&P Scientific.
Please contact V&P Scientific at the address below for return authorization and shipping instructions.
This warranty is made in lieu of other warranties expressed or implied including the warranties of
merchantability and fitness for a particular purpose. V&P Scientific shall not be liable for loss or
damages arising from the use of these products nor for consequential damages of any kind.
If technical assistance is required, contact: V&P Scientific, Inc. at 858-455-0643 or
