V&P Scientific, Inc.
5
Technical Note 109
CLEANING AND STERILIZATION
The VP 756CP-96B Bubble Paddle Reservoir is made from Delrin and
CANNOT
be sterilized by
autoclaving or hot air oven. Sterilize by treatment with 10% bleach for 5 minutes followed by rinsing
with sterile H
2
O, then alcohol and air drying. Be sure that the inlet and outlet tubes are thoroughly
exposed to the bleach and rinsed well. To clean, use mild detergent, rinse with H
2
O and alcohol.
SAFETY PRECAUTIONS
The use of motor controls, like that of all utilization of concentrated power, is potentially hazardous.
The degree of hazard can be greatly reduced by proper design, selection, installation, and use, but all
hazards cannot be completely eliminated.
The following safety precautions must be observed during all phases of installation, operation, service,
and repair of this motor control product. Failure to comply with these precautions or with specific
warnings elsewhere in this manual violates safety standards of design, manufacture and intended use
of the products. V&P Scientific assumes no l
iability for the customer’s failure to comply with safety
requirements and practices.
WARNING
To avoid personnel injury caused by electrical shock, do not
remove the cover of the control when the power is ON.
CAUTION
Do not disconnect motor during operation. Otherwise, over-
current breakdown may result.
