-13-
-14-
ELECTRIC SCOOTER QUICK FIX
5.1
Safety riding
•
Learn about your electric scooters-—Before riding an electric scooter please learn the functions.
5.2
Ride skills
-• The position of your feet—Before riding put your foot on the front of the scooter the other foot on the ground, to ensure that the ride route is
smooth.
•
Before starting, use the foot on the ground to slide forward (like riding a no-power scooter).
•
Immediately press the accelerator button, the body leans forward, so you can avoid falling backward due to inertia , so that electric scooters
will enter the working state.
•
Avoid putting your body on the handle bar in the process of acceleration and deceleration.
•
In the acceleration and deceleration, avoid putting your body on the handle bar; one foot ahead,one foot behind (as in the skateboard /
surfboard, one foot ahead, the other foot back, this is more comfortable).
•
Turn---The principle of turning the electric scooter is same as the surfboard/ skateboard/skis, the handle is parallel to the body, observe
carefully and make sure the turn is safe before turning.
•
Brake—The center of body gravity is at the back, ensure to brake through the feet rather than the handle or joystick, it is best to know how to
adjust the center of gravity when stopping, in addition, be much more attention, such as turning over ("emergency stop") or wear, as well as the
damage of handle rod, joystick, steering system.
Maintenance of flat tire of electric scooter
•
Check if the electric scooter charger is unplugged and cut-out
•
Place the electric scooter body on a high and solid table, make the front and rear wheels in the air.
•
Use the universal tool to open the rear plastic cover.
•
From the right side of the electric scooter; gently pull the wires that connect the motor.
•
Use a 15-18 external six-feet handle to remove the motor's screws and take out the motor.
♦
Remember the order of the motor washers.
♦
Put the tires out of the motor with a professional crowbar (not plastic or too small). Do not damage the motor, wheels, tires and inner tubes
during this process..
♦
Change the inner tube.
♦
Tire is installed in situ, stall the tires on the wheels hub after applying the hand sanitizer or soapy water to the wheels hub, finish the operation
with hands, not any tools.
♦
Inflate the tire to 45PSI of tire pressure, check whether your maintenance is perfect.
♦
Install the electric scooter back according to the opposite steps described above.
.
RIDE SKILL
Make sure the charger of the electric scooter is pulled out and the power is turned off.
(Required tools)
Содержание Scoot E-5
