4
CONNECT AND OPERATE
1.
Trace and cut out a single-gang hole in a wall and insert a single gang electrical box
2.
Connect speaker and power cables while making sure that power is not active and
the unit is turned off by turning the rotary dial counter-clockwise
3.
Install the PA230WP into the electrical box in the wall
4.
Connect power on the opposite end and turn on the rotary switch clockwise to turn
on the amplifier
5.
Bluetooth (BT) status LED will quickly blink to be in open pairing mode
6.
Search and connect to the Bluetooth labeled: Pulse BT
7.
Enter the password that was found on the sticker on the back of the unit before
installing into the wall
8.
NOTE: After 3 minutes of no pairing or no signal, the unit will automatically go into
pairing mode
9.
For Aux-In source, plug-in audio cable and play
10.
NOTE: The unit will automatically switch between Bluetooth (BT) and Aux-In, but if
both sources are connected and are LIVE, priority is given to the Bluetooth source
NOTE: Ensure all speaker and power wires are run in accordance to local laws and
regulations. Before inserting the amplifier into the electrical box and wall, either note or
remove the Bluetooth password found on the sticker of the back of the unit.