www.vanco1.com
800.626.6445
6
CONNECTION DIAGRAM
CONNECT AND OPERATE
1. Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite Receiver, etc.
to the HDMI input on the compatible product.
2. Connect a display such as an HDTV or HD Projector to the HDMI output on the Receiving unit.
3. Connect a single Category 5e/6/7 up to 164ft/50m to the UTP output of the Transmitting unit, and the
other end to the UTP input of the Receiving unit.
4. Power on each device in the same sequence (receiver will already be powered when transmitting devise is
plugged in and powered on)
At this point the display connected should display the connected source signal. If no signal is being displayed,
connect a shorter Cat5e/6 cable (jumper or patch cable). If a display is having difficulty receiving a signal,
access the display’s menu and adjust the resolution (lowest to highest until signal is displayed). A 24 Hz or
30 Hz refresh rate may work better than 60 Hz or higher. Use the source remote at the receiver emitter to
test IR functionality. If the IR remote function is not responding, check the emitters to ensure they are placed
correctly and are plugged into the correct IR jacks on both the transmitting device and receiver.
EDID
The EVRX2006 is equipped with EDID management, however there is no need to adjust any dip switches or
dials, the unit automatically reads the EDID from the display and save it internally. This feature was created
for the installer in mind, for a plug and play installation!
