Vanco Evolution EVEXHDB1, Руководство пользователя

Страница: 7 / 12

www.vanco1.com 800.626.6445 7
IR
IR PASS-THROUGH
The bi-directional IR system allows you to control the source that is connected to the extender unit, from the
display; or the display from the source, not simultaneously. There are two important things to note when
setting up the IR system:
1. The IR Receiver (IR RX) is always what you point your remote at to send an IR signal. This pigtail is placed
at the display for controlling the source; or at the source for controlling the display.
2. The IR Blaster (IR TX) is what sends the IR signal to what you are intending to control, whether it’s the
source or the display. This pigtail is placed at the source; either pointed at the source, or placed on the
front panel of the source, see below for placement tips. Or placed at the display to control the display
from the source.
To Control the Source:
1. Plug the IR TX/Blaster
into the IR out Port on the
Transmitter
2. Plug the IR Receiver into the
IR In Port on the Receiver
To Control the Display:
1. Plug the IR Receiver into the
IR In Port on the Transmitter
2. Plug the IR TX/Blaster into
the IR Out Port on the Receiver
IR TX IR RX
IR TX
IR TX
IR RX
IR RX