www.vanco1.com
800.626.6445
6
CONNECTION DIAGRAM
CONNECT AND OPERATE
1. Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite Receiver, etc.
to the HDMI input on the Transmitting unit.
2. Connect a display such as an HDTV or HD Projector to the HDMI output on the Receiving unit.
3. Connect a single Category 5e/6/7 up to 164ft/50m to the UTP output of the Transmitting unit, and the
other end to the UTP input of the Receiving unit.
4. For power, plug in either the Transmitting unit or Receiving unit with the included power supply, opposite
unit will not have to be plugged in as it features Power over Ethernet (PoE).
5. Power on each device in the same sequence (receiver and transmitter will already be powered when either
unit is plugged in)
At this point the display should show the source signal connected to the extender set. If no signal is being
displayed or issues such as blinking, artifacts, etc, connect a shorter Cat5e/6 cable (jumper or patch cable),
if the issue is corrected, the Cat5e/6 could be the issue. If a display is having difficulty receiving a signal,
access the display’s menu and adjust the resolution (lowest to highest until signal is displayed). A 24 Hz
vertical refresh rate may work better than 60 Hz or higher. Use the source remote at the receiver emitter to
test IR functionality. If the IR remote function is not responding, check the emitters to ensure they are placed
correctly and are plugged into the correct IR jacks on the Extender set receiving and transmitting units, see IR
section for setup and installation).
