www.vanco1.com
800-626-6445
6
CONNECT AND OPERATE
1. Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite Receiver, etc.
to the HDMI input on the Transmitting unit.
2. Connect a display such as an HDTV or HD Projector to the HDMI output on the Receiving unit.
3. Connect a single RG6 coax up to 100m/328ft or a single RG59 up to 60m/196ft to the output of the
Transmitting unit, and the other end to the input of the Receiving unit.
4. For power, plug into both the Transmitting unit and Receiving unit with the included power supplies.
5. Power on each device in the same sequence (receiver and transmitter will already be powered when either
unit is plugged in
At this point the display connected should display the source signal connected to the extender set. If no signal
is being displayed, connect a shorter Coax cable (jumper or patch cable). A 24 Hz vertical refresh rate may
work better than 60 Hz or higher. Use the source remote at the receiver emitter to test IR functionality. If the
IR remote function is not responding, check the emitters to ensure they are placed correctly and are plugged
into the correct IR jacks on the Extender set of the receiving and transmitting units.
BluRay® Player
HDTV
HDMI
HDMI
HDMI over Coax Cable
IR Transmitter
Front
Back
Front
Back
IR Receiver
